5
.
The Color Of The Indicator Light
1) When the machine is turned on but not working, the button light is off, and the
color is not displayed, which is normal.
2) Connect the WIFI, when the machine is transmitting signals, the button light will
change from purple to red gradient; After the wifi connection is successful, the button
light will be off, and the color will not be displayed,which is normal.
3) When the machine is reset, the color of the button light is a blue-green gradient.
After the reset is completed, the button light is off, and the color is not displayed,which is
normal.
4) When the processing file is receiving, the button light will be steady yellow. After
the processing file is received, the button light will turn green and steady. Click the button
to process
.
5) When receiving the upgrade file, the button light will turn yellow and steady.
6) When the machine fails and alarming, the button light will be red and steady.
6. When the image taken by the camera has a large deviation from the actual cutting
image (the deviation within 2mm is normal)
When the deviation is too large (as shown in Figure 11), please contact the staff for
remote correction. The customer is required to assist in the following two steps to correct:
Figure 11
1) A4 paper, spread on the work table (as
shown in Figure 12), wait for the button light to
turn green automatically, and then click the button
for processing.
Note: The paper must not be cocked
Figure 12
52
Summary of Contents for Desktop 3D Laser Printer
Page 1: ......
Page 22: ...18...
Page 39: ...Click The material selection list pops up Click to calibration camera 35...
