8
FTR7 INDOOR RACER
ASSEMBLY INSTRUCTION
PREPARATION
A. Before assembling make sure that you will have enough space around the item.
B. Use the present tooling for assembling.
C. Before assembling please check whether all needed parts are available (at the above of this instruction
sheet you will find an explosion drawing with all single parts (marked with numbers) which this item
consists of.
STEP 1
Attach the Front Stabilizer (pt.15) to the Main Frame
(pt.16) using two sets of Ø10 Arc Washers (pt.5), M10
Domed Nut (pt.6) and M8*90 Carriage bolt (3).
Attach the Rear Stabilizer (pt.4) to the Main Frame
(pt.16) using two sets of Ø10 Arc Washers (pt.5), M10
Domed Nut (pt.6) and M8*90 Carriage bolt (3).
STEP 2
Slide the Vertical Seat Post (pt.10) into the seat post
housing on the main frame (pt.16).
Then slide the Seat Post (pt.12) into the Vertical Seat
Post (pt.10),then Secure using a flat washer 1 (20)
and L Shape knob (19).You will have to slacken the
knurled section of the L Shape Knob (pt.19) and pull
the knob back and then select the desired height. Re-
lease the knob and retighten the knurled portion.
Now fix the Seat (pt.13) to the Seat Post (pt.12) as
shown, and tighten the bolts around the screws under
the seat.