10
GB4.0 EXERCISE BIKE
ASSEMBLY INSTRUCTIONS
STEP 5. Handlebar Installation
Remove two M8x15 Bolt
s (14) and two
φ
8
xφ
16x1.5 Washers(15) from the Handlebar
(6).
Insert the Hand Pulse Sensor Wires (12)
into the hole on the Handlebar Post (5) and
then pull them out from the top end of the
Handlebar Post (5).
Attach the Handlebar (6) onto the Handlebar
Post (5) with two M8x15 Bolts (14) and two
φ
8
xφ
16x1.5 Washers(15)
that were removed.
STEP 6. Computer and AC Adapter
Installation
Remove four M5x10 Bolts (8) from the
Computer (7). Remove bolts with the Multi
Hex Tool with Phillips Screwdriver provided.
Connect the Hand Pulse Sensor Wires (12)
and Extension Sensor Wies(9) to the wires
that come from the Computer (7). Tuck wires
into the Handlebar Post (5).
Attach the Computer (7) onto the top end of
the Handlebar Post (5) with four M5x10 Bolts
(8) that were removed. Tighten bolts with
the Multi Hex Tool with Phillips Screwdriver
provided.
Plug one end of the AC Adapter(18) into the
power jack of the Power Supply Wire(17)
on the Front of the Left Chain Cover. Before
plugging in,make sure to check carefully the
specifications on the Adapter. Plug the other
end of the AC Adapter(39) into the electrical
wall outlet.
