9
GB4.0 EXERCISE BIKE
ASSEMBLY INSTRUCTIONS
STEP 3. Handlebar Post and Handlebar Post cover
Installation
Remove
six M8x20 Bolts
(20),four
Ø8xØ16x1.5
Washers (15)
,two
Ø8xØ20x2.0 Big Arc Washers(22)
and six Spring Washers Ø8 (21) from the Main Frame
(1). Remove bolts with the S6 Allen Wrench provided.
Insert the Handlebar Post
cover
(24) onto the tube of
the Handlebar Post (5) and Slide the Handlebar Post
cover
(24).
Connect the Sensor Wire (23) from the Main Frame (1)
to the Extension Sensor Wire (9) from the Handlebar
Post (5).
Insert the Handlebar Post (5) onto the tube of the Main
Frame (1) and lock with six M8x20 Bolts
(20),four
Ø8xØ16x1.5 Washers (15)
,two
Ø8xØ20x2.0 Big Arc
Washers(22) and six Spring Washers Ø8 (21)that
were removed. Tighten bolts with the S6 Allen Wrench
provided.
STEP 4. Seat Post, Seat Post Cover and Seat
Cushion Installation
Remove three M8
Nuts (36) and three Ø16xØ8x1.5
Washers (15) from underside of
the Seat Cushion (38).
Then attach the Seat Cushion (38) onto the triangle
plate of Seat Sliding Tube(4) with three M8 Nuts
(36) and three Ø16xØ8x1.5 Washers (15) that were
removed.
Remove one
Ø8xØ20x2.0 Washers (35) and one
Round Knob M10 (34)from below of the Seat Sliding
Tube(4) .
Then attach the Seat Sliding Tube(4) onto the Seat
Post(3) with one Ø8xØ20x2.0 Washers (35) and one
Round Knob M
10 (34)that were removed.
Insert the Seat Post
cover
(33) onto the tube of the
Seat Post (3) and Slide the Seat Post
cover
(33).
Attach the Seat Post (3) onto the tube of the Main
Frame (1) with the Round Knob Knob M16*1.5(32).
NOTE:When adjusting the height of seat post,the
maximum insert depth mark line cannot highter
than the edge of seat post cover.
Adjusting the seat cushion:
Release the Round Knob M10 (34) and then slide the Seat Sliding Tube(4) forth or back direction
for the suitable positon.Tighten the Round Knob(32
) after adjustment.
