Page 5
Fine Tuning Cursor Control
Since the Air Mouse uses standard Windows or Mac mouse drivers, there are no additional drivers to install. Any
settings that are available to a standard desktop mouse (such as cursor tracking speeds and mouse double-click
speeds) are also available to the GO 2.4 GHz PRO Air Mouse.
Multiple factors will determine how you adjust the Air Mouse to suit your personal preference including screen
resolution and driver version. While becoming familiar with your mouse and getting a feel for the “in air” method of
cursor control, Gyration recommends adjusting your mouse driver to the following settings:
o
Pointer Speed – Average. Some new users prefer this setting to be slightly slower than average.
Advanced users will increase the speed so that less wrist movement gives them more screen
coverage with the cursor.
o
Acceleration – Low or Off.
Note: Refer to your operating system’s documentation for additional information on customizing your mouse
properties.
GyroTools™ Media Control Software PRESENTATION EDITION
GyroTools
™
is a suite of software tools that enhance the functionality of the Air Mouse.
1. To install the GyroTools software, run SETUP.EXE from the Flash Drive partition named “GyroTools” and
follow the on-screen instructions.
2. Once the installation is complete, click on the GyroTools icon in the Start menu to launch the GyroTools
application.
3. Tools can be assigned to a double right–click, a right–click and hold or a right–click followed by left–click.
There are other methods to activate tools, such as screen hotspots, swipes and scheduled events.
Note:
Once GyroTools has been installed, complete operating instructions are available by accessing the online
help.
Assign your favorite tools to Swipes on your GyroTransport Air Mouse and put advanced presentation techniques
at your fingertips. To assign tools using the Drag and Drop Toolbox:
1. Select the tool group (such as General, Internet, or Media) located at the bottom of the GyroTools window
that contains the tool(s) you want to assign.
2. Left–click and hold the desired tool. Drag the tool onto the icon square next to the button action or Swipe
direction that you wish to assign the tool to and release the button.
Troubleshooting
Symptom
Reason
Solution
Cursor is visible but shows
no movement
Gyroscope not activated
Press or double click activation button on top of
GyroTransport Air Mouse.
Cursor movement is
choppy or erratic
Radio Interference
Move receiver away from other electronic devices (i.e.,
monitor, speakers, radio, etc.)
Cursor moves too fast or
too slow
Speed or acceleration not set properly
Change the cursor tracking speed or acceleration setting in
the mouse control panel
Cursor drifts on the screen
Sensor may require recalibration
???
