background image

Safety Instructions

Low power protection

Instructions for care and maintenance

Ready to fly

1. Keep the helicopter and the box away from small children.

2. Keep a safe distance from high speed rotating propellers to avoid injury.

3. First time users should be gentle with the throttle to avoid crashing the helicopter or any 

    potential injuries.

4. After flying, please turn the remote controller off first, then the helicopter.

5. Keep the charging battery away from fire and humidity.

6. Do not fly the helicopter near pets, young children, elderly and disabled people.

7. Non rechargeable batteries are not to be charged; Different types of batteries or new and 

    used batteries are not to be mixed; Batteries are to be inserted with correct polarity; 

    Exhausted batteries are to be removed from the product. The supply terminals are not to be 

    short circuited

8. When not in use, please turn off the power of controller and helicopter. When the helicopter 

     is not in use for a long period of time, remove the batteries from remote controller.

1. Use a place away from any people, pets and obstacles.

2. Turn helicopter power switch “ON”. The helicopter lights will flash. It will search the signal 

    from controller.

3. Turn the remote controller “ON”. The indicator light will flash. Push the left control throttle 

    up and down. The indicator light will be constant.

4. Push the left control throttle up slowly and start to fly.

When the helicopter’s battery is low, the system will cut-off the power to avoid excessive 

discharge. This will reduce any damage to the battery.

1. Please clean the helicopter and controller with a clean soft cloth.

2. Store the helicopter in a dry, clean place. Keep the box for storage.

3. Inspect the helicopter before use. Do not use if any parts are damaged or broken.

Summary of Contents for S 107C









Reviews: