Gyros S 107C, Using Instructions

Battery Installation & Charging

Charging the helicopter battery
A. To charge the helicopter with 

     remote Control

1. Be sure to switch off the helicopter power.

2. Charging by A: The charging cable is accessible when sliding down the front panel of the controller. 

    Plug it in the helicopter port, and turn ON the controller. The indicator should turn on when the 

    battery starts charging. The indicator will turn off when the battery is fully charged (About 40-50 

    minutes).

Charge by B: Plug the provided USB charging cable into the helicopter, then insert the USB plug into 

your computer. The USB indicator should turn on when the battery starts charging. The USB indicator 

will turn off when the battery is fully charged (About 40-50 minutes).

The helicopter contains a built-in Li-Po battery, please pay attention to the following matters:

- Keep the battery away from fire and heating sources. It could damage the battery or cause it to 

   explode.

- Keep the helicopter and the battery away from water.

- Only charge the helicopter with the provided adapter.

- Do not remove or dismantle the built-in battery.

- Do not leave unattended when charging.

B. To charge the helicopter with 

     USB (Connected to computer)

1. Use a crosshead screwdriver to remove the controller battery cover. Insert 6 batteries 

(size AA, 1.5V) observing the correct polarity indicated in the compartment. Replace the 

battery cover and secure the screw.

Different types of batteries or new and used batteries are not to be mixed;

Batteries are to be inserted with correct polarity;

Exhausted batteries are to be removed from the product;

The supply terminals are not to be short circuited.

Charge time: 40-50 minutes—Fly time 5-6 minutes!