Battery Installation & Charging
Different types of batteries or new and used batteries are not to be mixed;
Batteries are to be inserted with correct polarity;
Exhausted batteries are to be removed from the product;
The supply terminals are not to be short circuited.
Charge time: 50-60 minutes—Fly time 5-6 minutes!
Battery Installation in the remote controller
Charging the helicopter battery
A. To charge the helicopter with
remote Control
1. Be sure to switch off the helicopter power.
2. Charging by A: Plug the provided USB charging cable into the helicopter, then insert
the USB plug into the remote controller charge port. The USB indicator should turn on
when the battery starts charging. The USB indicator will turn off when the battery is
fully charged (About 50-60 minutes).
Charge by B: Plug the provided USB charging cable into the helicopter, then insert the
USB plug into your computer. The USB indicator should turn on when the battery starts
charging. The USB indicator will turn off when the battery is fully charged (About 50-60
minutes).
The helicopter contains a built-in Li-Po battery, please pay attention to the following matters:
- Keep the battery away from fire and heating sources. It could damage the battery or cause
it to explode.
- Keep the helicopter and the battery away from water.
- Only charge the helicopter with the provided adapter.
- Do not remove or dismantle the built-in battery.
- Do not leave unattended when charging.
B.To charge the helicopter with USB
(Connected to computer)
1. Use a crosshead screw driver to remove the controller battery cover. Insert 4 batteries
(size AA, 1.5V) observing the correct polarity indicated in the compartment. Replace the
battery cover and secure the screw.
