Charging the helicopter.
Installing transmitter batteries
The charging time is about 60 minutes; flying time is about 5 minutes.
Charging instructions: switch off the helicopter (on/off switch is at the top of the
helicopter); insert the charging cable into a USB port on your computer (the charging
cable indicator light will turn on); connect the charging cable to the helicopter (the
charging cable light will go off); the charging time is about 60 minutes; unplug the
charger cable when the light turns on.
Transmitter battery installation: open the battery cover at the back of the transmitter.
Install 4pcs AA batteries according to the polarity indications (Note: batteries are not
included).
Installing and charging the battery
Battery Cover
4 x AA Batteries
Make sure the equipment is switched
OFF before charging.
1. During the battery installation, it must be ensured that the
polarities of the batteries are matched with that of the battery
box. No battery shall be installed with the opposite polarity.
2. Please do not use new and old batteries together.
3. Please do not use different types of batteries together.
4. Do not use rechargeable batteries.
Important: battery charging information
- Rechargeable batteries should be removed from the toy before being charged.
- Rechargeable batteries should only be charged under the supervision of adults.
- Exhausted batteries should be removed from the aircraft.
- Caution: Risk of explosion if battery is replaced with incorrect ones. Please dispose
the batteries according to the instructions.
-2-
