9
CONVERGYS 150
EN
Translation of the original instructions
9
OPERATION
150 W MODEL:
1) Connect the Convergys to the cigarette lighter socket of a vehicle.
2) Switch the inverter ON and connect your equipment to the Convergys (230V or USB 5V).
3) After use, unplug your equipment and then switch OFF the Convergys and disconnect it from the cigarette lighter.
TECHNOLOGY DATA
MODEL
Convergys 150
Input voltage
DC 12 V
Output voltage
AC 220 V - AC 240 V
USB Output
DC 5V (2100 mA)
Continuous power
150 W
Peak power
300 W
Output frequency
50 +/- 3 Hz
Output waveform
Modified sine wave
Max Output efficiency
85%
12V input, No load current
< 0.45 A
Low voltage protection
DC 10.2-10.8 V
Over voltage protection
DC 15-16 V
Overload shutdown
18A--22 A
Operation temperature
5° C – 35°C
TROUBLESHOOTING
SYMPTOM
CAUSES
REMEDIES
No voltage output
Bad connection
Check the cigarette lighter plug and cable
connections
Weak battery
Check the vehicle battery
Start the engine of the vehicle if necessary
Thermal overload
Stop the device. Leave the inverter to cool
ensuring adequate ventilation.
Fuse failure (in the inverter or vehicle)
Check and replace fuse
The device turns ON and
OFF intermittently
The direct load is too high.
Reduce the load
The inverter turns OFF
when a connected device
is switched ON
The starting current is too high.
Check if the maximum power of the inver
-
ter is suitable for the required power of the
device
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
Summary of Contents for CONVERGYS 150
Page 18: ...18 CONVERGYS 150 RU 18 50 C...
