17
Inverter 70
24 HF
4.
The result « End »: Indicates the cables are in good working condition, and will be displayed
for 10 seconds - after which the Inverter will revert back to the main menu.
5.
If no message is displayed during this time, this indicates there may be an error with the
cables. After switching off the charger, clean the contacts then check the charge cables
and change them if necessary. After this is done, restart the « check cables » cycle.
Charge End / Floating mode "FLt"
After the battery has been charged, 'Floating' mode continues to deliver a current to the battery to
maintain a maximum charge.
This function is initially active => display « FLt ».
To disable this function, select « OFF ».
Restart "LP":
The automatic restart function only works in charge mode - it enables an automatic restart for the
charger in the event of unexpected power loss.
By default, the function is inactive : displays « off ».
To activate this function, select « LP » for LOOP.
PROTECTION
The Inverter is protected against short-circuits, polarity inversions and engine starts. It has an anti-
spark feature which prevents sparks whilst connecting the inverter to the battery. The inverter will not
deliver current if there is no battery detected (no voltage in the clamps). The charger is protected by
1 x 80A (Ref: 054651) internal fuse.
TROUBLESHOOTING
PROBLEMS
CAUSES
SOLUTIONS
A warning beep sounds
+ the warning LED illuminates
+ the display shows :
Inverter 70HF detects a
polarity reversal in the
clamps.
Connect the red clamp to
the "+" terminal, and the
black clamp to the "-"
terminal
C
H
A
R
G
E
R
M
O
The display shows :
« Bat »
+ the warning LED flashes
The charger cannot detect a
battery
Ensure the battery terminals
are clean, and the clamps
are securely connected
C
H
A
R
G
E
R
M
O
D
E
C
H
A
R
G
E
R
M
O
D
E
The display shows :
« HI »
+ the warning LED flashes
A consumer has been left on
(eg : Headlights)
Turn off any active
consumers, disconnect the
clamps and re-connect to re-
start the charge
Alternatively: disconnect the
battery from the vehicle
before charging.
