12
descent. Position yourself so that you have an overview of the situation and can
act quickly in the event of a problem.
Position yourself outside the security perimeter and press the "UP" button on the wired remote control so as to raise
the ramps by 2-3 cm. Without going under the vehicle, with one hand or foot raise the locking bars so that the 2 cams
rest on the ground.
Press "DN" (down) until the ramps return to the initial position. Please make sure that the cams slide smoothly
through each passage of the locking blocks. Otherwise, pull the vehicle up by pressing "UP" to catch up and until you
can put the release cam back on the ground.
The buttons on the remote control always return to their initial position when
the operator does not press them to ensure that all manoeuvres are voluntary.
After an operation with the remote control, it is strongly recommended to put it
in its case which can be fixed to a fixed support (not accessible by children).
CONTROLS AND MAINTENANCE
Inspections and maintenance work must be carried out by authorised personnel at the maintenance intervals specified
in this manual. In order to guarantee a long service life and proper use of the QUICK LIFT, the following points must
be observed.
•
Turn off the power to your Quick Lift before performing any maintenance.
•
Only original spare parts must be used "Spare parts"»
•
The recommended maintenance intervals must be adhered to "Maintenance table".
•
For maintenance work that is not shown or indicated in the operating instructions, contact your
distributor and/or the manufacturer.
Clean the QUICK LIFT at least once a week to remove all dust and dirt that could
degrade the proper functioning of the product in the long term. Use self-cleaning
cloths. Do not use any water nor flammable or corrosive liquids.
Visually inspect your QUICK LIFT before each use. Do not use it if you detect
damage or severe wear and tear.
Carry out maintenance work only when the QUICK LIFT is lifted, locked and
unloaded.
MAINTENANCE TABLE
Maintenance
intervals
Tasks
Remarks
Monthly
Check, clean and lubricate all moving parts, especially
the pins and sliding surfaces of the locking bars.
Check the condition of the rubber spacers and clean
them.
Check the locking bars, the locking cams and the
condition of the pins.
Check the condition of the hydraulic hoses, the
cable of the wired remote control and the power
supply cable.
Check the hydraulic oil level
Refer to "Check and lubrication point".
Replace if necessary (Refer to the exploded view
"Spare parts")
Complete if necessary.
Annual
"Regular security check"
For the test log, see
"Regular security check"
Every 5 years
of service
Replace the complete set of hydraulic hoses and the oil
in the hydraulic system.
Refer to the exploded view.
«Spare parts»
Maintenance must be carried out at regular intervals.
Summary of Contents for LUXMAIN QUICK LIFT L520E
Page 17: ...17...
