GYS LUXMAIN QUICK LIFT L520E, Operating And Control Manual

6 

LIFT does not come into contact with areas close to the airbag activation sensors during and after the climb. 

Do not place the rubber spacers on an area with plastic lining. 

Take care of electrical cables and hydraulic hoses, do not crush them or step on them. 

In the event of a violent impact on the load-bearing and/or structural elements of the QUICK LIFT, it is imperative to 

take the product out of service and contact your dealer or the manufacturer in order to assess the damage before 

putting it back into service. 

In case of doubt about the strength of the vehicle structure (presence of rust) - Do not lift the vehicle. 

Intended use also includes familiarising yourself with these operating instructions and complying with all the 

instructions contained therein, in particular the safety instructions. 

Enforce safety and risk prevention standards in the country's workplaces. 

In addition, this also includes the obligation to carry out all regular inter-wall inspection and maintenance work. 

In the event of improper use of the lift, the operational safety of the QUICK LIFT is not guaranteed. 

Damage to persons and property, also on vehicles, caused by improper use of the device is in no way the 

responsibility of the manufacturer, but of the operator handling the QUICK LIFT. 

QUICK LIFT must not be used in a potentially explosive atmosphere and it is not recommended to work next to a heat 

source. 

It is forbidden to use spare parts other than original parts certified by the manufacturer. 

Make sure that your QUICK LIFT is in one of the two locked positions before you start working around or underneath. 

At the end of a work session, return the vehicle to the ground to avoid operating the QUICK LIFT with a full load for a 

long period of time. 

PACKAGING AND UNLOADING 

The QUICK LIFT is packed in two parcels on a pallet. In a pocket on the outside of the package you will find the 

QUICK LIFT operating and testing instructions. The larger package contains the two booms and accessories and in the 
smaller package is the hydraulic power pack. On delivery, check for external transport damage. In case of visible 

damage, leave the goods and packaging as they are. Do not use the goods and contact your dealer directly. Failing 

this, a reservation must be made to the carrier. Unloading is done by means of a pallet truck or a forklift truck. 

INDIVIDUAL COVERAGE 

The operator must be equipped in accordance with the occupational risk prevention standards applicable in his 

country and must adopt all necessary measures to maintain safety at his workstation. During manoeuvres, the 

operator must ensure his own safety and that of the people and objects around him. The operator must take into 

consideration all the recommendations quoted in this manual. 

Hydraulic fluid is dangerous if splashed in the eyes or if it comes into 

contact with blood. In this case, contact your doctor immediately. Never 

reach over your hand to check for a hydraulic leak: risk of cut and 

contamination in the bloodstream that could lead to death. 

START UP 

Make sure you have the necessary protection: pair of glasses, safety shoes and gloves. 

Step 1: Lay the two booms on the ground parallel by aligning the hydraulic hoses.

The ramps are very similar but they are not interchangeable.. The mechanical 

safety must always be on the outside and the ramps pointing in the same 

direction.