10
PSW 600 W / 1000 W / 1500 W - 12 V /
1500 W - 12 V + RC / 1500 W - 24 V
EN
Translation of the original instructions
10
b. Scope of electric appliance that inapplicability with the USB
Only for inverters with USB port ;
USB is only for charging , do not have date exchange function;
Before charging please check carefully if the charging current of the appliance is under the inverters current, if it is
exceed the charging current of the inverter please do not use, or it may destroy the USB port.
Some appliance must charging use certain charger, please don’t charge with USB port.
2. To save energy, the fan will not work unless the under two situations:
The fan will work when the load is exceed 30% of the related power of the inverter;
When the inside temperature of the inverter exceed 60 degree, fan work.
3. About extended cable using:
We do not recommend use extended cable between the inverter and the battery, because it will case lost of DC electri
-
city and affect the effect of the inverter.
If you must use an extension cable, we recommend using high quality cables with larger cross-sections to reduce the
risk of electrical losses.
CONNECTION
•
Checking if the inverter is in «OFF» status; connect battery with the supplied cable.
• Ensure the battery voltage and the inverter input voltage matching;12V inverter only work with 12V battery and 24V
inverter only work with 24V battery.
• Connect the postive terminal with the postive polar of the battery and the negative with the negative polar and
please keep the inverter in “OFF” status that,’s very important for the inverter.
Warning: Keep the connection tightly or will be very dangerous.
• Checking the connection again before the next step
Warning: Do not reverse connection or it may destory the inverter.
•
Press the ON/OFF button for 5 seconds, the green LED lights up, the product is ready for use. If the inverter alarm
is triggered, turn off the product and refer to the alert list.
REMOTE CONTROL
(PSW 1500W RC - Ref.
027701)
appui
press
drücken
apretar
pers
stampa
Input display
Output display
The remote control allows you to control the converter remotely (max 5 m). Its digital display also provides informa
-
tion on the battery status and W consumption of the connected electrical device.
The monitoring remote control only works on PSW 1500W RC (ref. 027701).
It must be connected to the converter when it is not powered on.
Use of the system
1. Connect the remote control to the converter (1). It is possible to fix the remote control once the connection has
been established.
2. Press button (2) for a long time (> 3 s). The converter lights up, the Power LED turns green.
3. The “INPUT DISPLAY” screen provides information about the battery voltage.
The “OUTPUT DISPLAY” screen informs of the power consumed by the device connected to the converter.
A simple press of the button (2) switches from one to the other.
4. Press and hold (2) (> 3 s) to turn off the unit.
Indicators
The green indicator is the power indicator. The red indicator indicates a fault :
F01
F02
F03
F04
F05
Low volt
Over volt
Over load
Over temp
Output short-circuit
1
2
