GYS PTI.G, Manual

53

GYSPOT INVERTER PTI.G

EN

The machine counts the number of points achieved with each arm independently. A warning 

message appears on the screen when the limit of the points made by the headings is reached. The 

message remains displayed after each point until the counter is reset.

If the caps are not changed after the warning message is displayed and the count is simply reset, they can deteriorate and have a negative 

impact on the quality of the weld.

RECORDING FEATURES

The Identification mode is optional and can be activated using the «settings» menu.

If the identification mode is switched off, il suffit de saisir un nom de rapport et de l’activer pour mémoriser les points de soudure effectués.

The log allows to store the parameters of the spots made using the clamp. It is available in all the modes by pressing the 2 buttons 

 and 

.

The user program is available in all modes by pressing the 

 and 

 buttons.

Report (log)

Saving a report allows you to retrieve the data of a series of spot made with using the clamp, and to 

save them on the memory card so that they can be retrieved from a PC for example. GYS provides 

a software called GYSPOT to read the SD card and edit the logs on a PC. This GYSPOT software is 

stored on the SD card as well as the user manual.

By default, this feature is disabled when the machine is switched on. Pressing the recording button 

(on/off) and the «mode» button starts recording the report in the selected log. Pressing the record 

button again (on/off) stops the current recording.

The log created contains: an ID entered by the user, as well as for each spot performed, the tool and arm used, the machine settings (power and 

pressure). It also contains the following possible error messages that may have occurred during its recording: I LOW, P LOW, PB CAPS.

The ID is entered using the 4 keys +, -   or 

. When entering an identifier already in use, the machine will record the new points in succession, 

without deleting the previous ones.
The 

 button is used to retrieve a previously saved report and read it back on the screen. 

The current recording must be stopped by pressing the 

 button before it can be displayed on the screen. The 

 button is used to exit the 

report view mode.

To delete the contents of a report, you must 
display it on the screen using the button 

.

Then press the 

 button. 

The following message appears on the 

screen.

When the triangle is displayed, a second press 
on the 

 button erases the content of the 

report displayed.

The triangle disappears from the screen auto-

matically after 3 seconds.

Identification mode

If the identification mode is set to «ON», all mandatory fields in the repair order must be entered to 

allow the weld to go ahead or the machine will display «identification fault».

To activate and deactivate the identification mode, an SD identification card must be inserted in the 

BP card reader instead of the SD card containing the programs.
The settings screen is activated by pressing and holding down the 

 button for 2 seconds.