12
Manuel d’utilisation
WF 35
Notice originale
INSTALLATION – FONCTIONNEMENT PRODUIT
Seul le personnel expérimenté et habilité par le fabricant peut effectuer l’installation. Pendant l’installation, s’assurer que le générateur est déconnecté
du réseau. Il est recommandé d’utiliser les câbles de soudage fournis avec l’appareil afin d’obtenir les réglages optimum du produit.
DESCRIPTION
Ce matériel est un dévidoir séparé pour le soudage semi-automatique « synergique » (MIG ou MAG), le soudage à électrode enrobée (MMA) et le
soudage à l’électrode réfractaire (TIG). Il accepte les bobines de fil Ø 200 et 300 mm.
DESCRIPTION DU MATÉRIEL (II)
1-
Support bobine Ø 200/300 mm
7-
Support torche
2- Motodévidoir
8-
Connecteur faisceau
3-
Cache pour sortie liquide du refroidissement (Bleu)
9-
Raccord gaz
4-
Cache pour entrée liquide du refroidissement (Rouge)
10-
Connecteur puissance
5- Connecteur Euro (torche)
11-
Support faisceau
6- IHM (Interface Homme Machine)
12-
Poignées de transport
13-
Tourelle
INTERFACE HOMME-MACHINE (IHM)
IHM
Veuillez lire la notice d’utilisation de l’interface (IHM) qui fait partie de la documentation complète du matériel.
ALIMENTATION-MISE EN MARCHE
Ce matériel a été conçu pour fonctionner exclusivement avec les générateurs en option de la gamme KRONOS / NEOMIG-i :
KRONOS 400T DUO
075337
KRONOS 400T G
075054
KRONOS 400T GW
075061
NEOMIG-i 400 G
075085
NEOMIG-i 500 G
075092
La liaison entre ces deux éléments se fait par l’intermédiaire d’un faisceau dédié en option :
Type de refroidissement de la torche
Longueur
Section
Référence
Air
5 m
70 mm ²
075443
10 m
70 mm²
075450
95 mm²
077553
Liquide
1.8 m
70 mm²
075467
5 m
70 mm²
075474
10 m
70 mm²
075481
95 mm²
075504
BRANCHEMENT DU FAISCEAU
Le raccordement ou le débranchement du faisceau entre le générateur et le dévidoir doit se faire obligatoirement générateur
hors tension. Couper l’alimentation en débranchant la prise, et attendre deux minutes.
Pour le branchement du faisceau entre le générateur et le dévidoir, voir page 3 ou 4.
INSTALLATION DE LA BOBINE
a
b
- Enlever la buse (a) et le tube contact (b) de votre torche MIG/MAG.