74
Instrukcja obsługi
WF 35
Tłumaczenie instrukcji oryginalnej
OPIS SPRZĘTU (II)
1-
Stojak na szpulę Ø 200/300 mm
7-
Uchwyt do palnika
2-
Podajnik drutu
8-
Złącze przewodu
3-
Pokrywa wylotu płynu chłodzącego (niebieska)
9-
Przyłącze gazowe
4-
Pokrywa wlotu płynu chłodzącego (czerwona)
10-
Złącze zasilania
5-
Złącze Euro (palnik)
11-
Podpora przewodu
6- HMI (Human Machine Interface)
12-
Uchwyty do przenoszenia
13-
Wieżyczka
INTERFEJS CZŁOWIEK-MASZYNA (HMI)
HMI
Należy zapoznać się z instrukcją obsługi interfejsu (IHM), która jest częścią kompletnej dokumentacji sprzętu.
PRZYCISK URUCHAMIANIA URZĄDZENIA
Urządzenie to zostało zaprojektowane do współpracy wyłącznie z opcjonalnymi generatorami KRONOS / NEOMIG-i:
KRONOS 400T DUO
075337
KRONOS 400T G
075054
KRONOS 400T GW
075061
NEOMIG-i 400 G
075085
NEOMIG-i 500 G
075092
Połączenie pomiędzy tymi dwoma elementami odbywa się poprzez opcjonalną, dedykowaną wiązkę:
Rodzaj chłodzenia palnika
Długość
Sekcja
Nr kat.
Air
5 m
70 mm²
075443
10 m
70 mm²
075450
95 mm²
077553
Płynem
1.8 m
70 mm²
075467
5 m
70 mm²
075474
10 m
70 mm²
075481
95 mm²
075504
PODŁĄCZENIE PRZEWODU
Podłączenie lub odłączenie przewodu pomiędzy generatorem a podajnikiem drutu musi odbywać się przy wyłączonym genera
-
torze. Wyłączyć zasilanie poprzez wyciągnięcie wtyczki i odczekać dwie minuty.
Podłączenie wiązki pomiędzy generatorem a kołowrotkiem znajduje się na stronie 3 lub 4.
MONTAŻ SZPULI
a
b
- Zdjąć dyszę (a) i rurkę kontaktową (b) z palnika MIG/MAG.
a
b
c
- Otwórz pokrywę bębna.
- Ustawić szpulę na jego podporze.
- Uwzględnić sworzeń napędowy (c) podstawy szpuli. Aby zamontować szpulę 200 mm,
należy maksymalnie dokręcić plastikowy uchwyt szpuli (a).
- Wyregulować hamulec szpuli (b) w celu uniknięcia splątania drutu przy zatrzymaniu
spawania. Ogólnie rzecz biorąc, nie należy dokręcać zbyt mocno, ponieważ spowoduje to
przegrzanie silnika.