5
Network Setup
Configure the LAN setup for the DVR to properly function with Ethernet connection.
•
From OSD main menu, select <
System Setup
>
Æ
<
Network Setup
>, set the <
LAN Select
>
item to <
LAN
> or <
PPPoE
> according to the network application, and enter <
LAN Setup
>.
•
For DHCP user, set the DHCP to <
ON
>. The IP address, Netmask, Gateway and DNS settings
are retrieved from network servers. DHCP is dynamic that the settings change from time to time.
•
For Non-DHCP user, set the DHCP to <
OFF
>. Enter an IP address, Netmask, Gateway, and
DNS settings. Please obtain the information from the network service provider.
•
To change the IP address, Netmask, Gateway and DNS value, press
UP/DOWN
keys to move
the cursor to the item. Use
LEFT/RIGHT
keys to access each section of the value and press
ENTER, then change the value using
UP/DOWN
keys.
•
PPPoE users must set the <
PPPoE Account
>, <
PPPoE Password
> and <
PPPoE Max Idle
>
as well.
•
When the settings are complete, press
ENTER
to confirm and save the settings; or
ESC
to
abort.
Dome Camera Control
Dome Camera Connection & Settings:
•
See section Pin Definition of Alarm I/O, RS-485, & Audio In for RS-485 port pin definition.
•
Refer to the following figure. Connect the R+, R- terminals on the dome camera to the D+, D-
terminals on the RS-485 port by RS-485 cable respectively.
•
To set up dome camera’s protocol and ID, press
MENU
to access the OSD main menu, and
select <
Camera Setup
>. Then select <
Dome Protocol
> and choose the corresponding
protocol. Next select <
Dome ID
> and choose a preferred ID number. Note that the ID number
must match the ID address defined by the dome camera.
•
To configure the RS-485 parameters, select <
System Setup
> from OSD main menu, and then
select <
RS485 Setup
>. The default
RS-485 settings are 9600 Baud, 8 Data Bits, 1 Stop Bit and
No Parity.
