ELECTRO FREEZE Soft Serve Model GEN-2080
185240
15
5 Part Names and Functions
— Shake
The following descriptions apply to figure 5-1. The number preceding the
part name corresponds to the number in the figure.
1.)
HEAD - ASSY. W/ACTUATOR:
Encloses the freezing cylinder and
provides an opening for product to
be dispensed.
2.)
BUSHING - BEATER BEARING:
Holds the beater in place at the front
of the cylinder. Must be inserted
into the head and lubricated before
assembly.
3.)
O-RING - HEAD:
Seals the head
to the freezing cylinder. Must be
lubricated.
4.)
and
5.)
O-RINGS - PLUNGER: (UPPER &
LOWER):
Seals the plunger in the
head. Must be lubricated to seal and
slide properly.
6.)
PLUNGER - DISPENSING BLACK:
Seals the product opening in the head
when closed. Allows product to flow
when open.
7.)
PUSH ROD - ASSY. PLUNGER
SWITCH:
Starts the freezer when
dispensing. Must be in place before
freezer will operate.
8.)
FUSE - SLO BLOW 1A:
Prevents the
spindle motor from overload.
9.)
SPINDLE - ASSY. FRONT MOUNT:
Mixes the shake as it is dispensed.
10.) O-RING - SPINDLE ASSY.:
Holds the
spindle in place.
11.) POST - PIVOT (Optional):
Holds
the handle in place when the spin-
dle is not used.
12.) O-RING - PIVOT POST:
Holds the pivot post in place.
13.) HANDLE - ASSY. SPINDLE HEAD:
Opens and closes the plunger to
start and stop the flow of product
from the freezer.
14.) KEEPER - ASSY. SPINDLE:
Se-
cures the handle to the head.
15.) KNOB - HAND:
Secures the head
to the freezing cylinder.
16.) O-RING - AIR RELIEF PLUG:
Seals the air relief screw in the
head.
17.) PLUG - AIR RELIEF:
Seals the
air relief opening in the head when
closed. Allows excess air to be
removed from the cylinder when
filling.
18.) EXTENSION-SHAKE SPIGOT:
Product flows from the head through
the extension.
19.) O-RING-SPIGOT EXTENSION:
Seals the extension to the head.
Summary of Contents for Electro-Freeze Genesis Series
Page 2: ......
Page 10: ......
Page 26: ...ELECTRO FREEZE Soft Serve Model GEN 2080 16 185240 5 Part Names and Functions Shake Figure 5 2...