ELECTRO FREEZE Soft Serve Model GEN-2080
185240
35
CAUTION
Make sure freezer is
depressurized before
proceeding.
CAUTION
To avoid electrical shock or
contact with moving parts,
make sure all switches are
in the “OFF” position and
that the main power supply
is disconnected. Some
freezers have more than one
disconnect switch.
Figure 9-4 Shaft Seal Assembly
9.2 Disassembly Instructions
— Shake
(continued)
1. If there is product in the freezer
refer to Section 14 Closing Procedures,
14.2 Draining Product.
2. Refer to figure 9-2. Remove the
plunger rod (7) by lifting up and swinging
the bottom out and down.
3. Pull the keeper (11) out of the
head (1).
4. Unplug the spindle motor (8) and
lift it upward, removing it from the head.
5. Remove the handle (10) and
hand knobs (15), and then pull the head
straight out by gently rocking the head
from the studs.
6. Remove the head bushing (2) and
the beater shaft from the cylinder.
7. Remove the scraper blades and
shaft seal from the beater shaft. Refer to
figure 9-3)
CAUTION
To prevent bacteria growth,
remove all O-rings when
cleaning. Failure to do so
could create a health hazard.
8. If you haven’t already removed
the drip tray (See Replacements Parts
Manual, Panel Assembly) and drip tray
insert from the front of the freezer, do so
now.
9. From the head remove the
plunger (6), and O-rings (4 & 5) from the
plunger.
10. Unscrew the air relief plug (13)
and o-ring (14), and head o-ring (3) from
the head.
11. Refer to figure 9-4. Remove
the cup seal and O-ring from the plastic
washer on the beater shaft seal assembly.
12. Remove mix tank, covers, and low
mix probe from inside the cabinet.
— continued
Figure 9-3 Beater Shaft Assembly
SEAL-ASSY. SHAFT
O-RING
BLADE-SCRAPER
BEATER-ASSY. SHAKE LONG
WASHER
CUP SEAL
CUP SEAL
WASHER
O-RING
Summary of Contents for Electro-Freeze Genesis Series
Page 2: ......
Page 10: ......
Page 26: ...ELECTRO FREEZE Soft Serve Model GEN 2080 16 185240 5 Part Names and Functions Shake Figure 5 2...
