ELECTRO FREEZE Soft Serve Model GEN-2080
40
185240
Correct assembly of the freezer
is essential to prevent leakage of
the product and damage to the
freezer. To assemble the freezer
you will need an approved lubricant (such
as Petrol-Gel). Make sure all parts of
the assemblies have been washed and
sanitized before assembling.
10 Assembly
— Soft Serve
1. Persons assembling the freezer
must first wash and sanitize their hands
and forearms with an approved sanitizer.
2. To assemble the shaft seal, install
the cup seal and O-ring on the bushing
(see figure 10-1). Apply a moderate
amount of approved sanitary lubricant
(such as Petrol-Gel) to the O-ring and the
face of the plastic bushing opposite the
bell portion of the seal. Do not allow any
lubricant to come into contact with the
bell-shaped rubber portion of the seal.
3. Install the shaft seal over the rear
of the beater shaft, with the bell-shaped
portion facing the rear, as shown in figure
10-2. Remove any excess lubricant from
the beater shaft.
Important:
Soft serve blades only have 2 holes
and are not interchangeable with the
3 hole shake blades. If the incorrect
blades are used the freezer could be
damaged.
4. Place the scraper blades on the
beater shaft, making sure the blades are
installed properly. (see figure 10-3)
CAUTION
To avoid electrical shock or
contact with moving parts,
make sure all switches
are in the “OFF” position
and that the main power supply is
disconnected. Some freezers have
more than one disconnect switch.
— continued
Figure 10-3 Proper blade installation
PROPER BLADE
INSTALLATION
IS WITH
FLAT SIDE
AGAINST
CYLINDER WALL.
Figure 10-2 Beater Shaft Assembly
Figure 10-1 Shaft Seal Assembly
Summary of Contents for Electro-Freeze Genesis Series
Page 2: ......
Page 10: ......
Page 26: ...ELECTRO FREEZE Soft Serve Model GEN 2080 16 185240 5 Part Names and Functions Shake Figure 5 2...
