ELECTRO FREEZE Soft Serve Model GEN-2080
42
185240
10 Assembly
— Soft Serve
(continued)
Important:
Use original Electro Freeze transfer
hose only. Your freezer will not operate
properly with any other type of hose.
Never twist the transfer hose when
assembling or installing.
Important:
Replace transfer hose every 30 days.
13. Assemble the MTS hose
assembly as shown in figures 10-5 and
9-6. The transfer hose has a red locating
line. Hold the mix/air inlet port with the
transfer hose mix port on your right and
the barbed air port facing away from you.
With the locating line up, slide the mix
transfer hose onto the port aligning it with
the small locating indent. Then slide a
clamp over the hose to secure it to the
port. Finger tighten only! The thumbscrew
must lie parallel to the mix/air inlet port.
14. Slide another clamp over the mix
transfer hose and connect to the barbed
end of the braided hose. Tighten the
clamp. Finger tighten only! The thumb
screw must lay horizontal as shown in
figure 10-6.
15. Slide the air tube over the air inlet
port and insert air meter in the opposite
end of the air tube.
16. Install o-ring on mix inlet tube
assembly and lubricate. Place the tube
assembly end into the port assembly
and swing retainer clip over to lock tube
assembly in place.
17. Install mix tube boot with flat side
first, over the tube assembly.
18. Insert the duckbill valve into the
bottom of the pickup tube. Push until the
two ribs are completely inserted.
Figure 10-6 Attaching Braided Hose
— continued
Figure 10-5 MTS Hose Assembly
Summary of Contents for Electro-Freeze Genesis Series
Page 2: ......
Page 10: ......
Page 26: ...ELECTRO FREEZE Soft Serve Model GEN 2080 16 185240 5 Part Names and Functions Shake Figure 5 2...
