ELECTRO FREEZE Soft Serve Model GEN-2080
185240
43
10 Assembly
— Soft Serve
(continued)
19. Refer to figure 10-7. Install the
MTS hose assembly by first placing the
clamp next to the braided hose, above
the roller bearing support on the right side
and push hose into slot. Place the transfer
hose under the rollers. While holding the
pickup tube stretch the hose so the left
hand clamp is above the roller bearing
support and push the hose into the slot.
Important:
Do not twist the hose assembly while
installing.
20. Check to ensure the transfer
hose is straight and centered on the
roller assembly making sure the locating
line is facing out. The line should be in
the same position at the inlet and outlet
guides of the roller bearing support, as
shown in figure 10-7.
21. Swing the shoe over hose and
tighten the swing clamp hand knob in
place until it bottoms out and will not turn
any further.
22. Insert the air tube into the
retainer in the back of the cabinet.
23. Insert the MTS cover over stud
see figure 10-8. Hose clamps should
be exposed. Tighten cover knob. Hand
tighten only.
Important:
The MTS will not operate unless the
cover is installed and secured by the
hand knob.
24. Loop the braided hose towards
you and slide the hose over the cylinder
inlet tube. Tighten the clamp. Make sure
the braided hose is not twisting transfer
hose.
Figure 10-7 MTS
— continued
Summary of Contents for Electro-Freeze Genesis Series
Page 2: ......
Page 10: ......
Page 26: ...ELECTRO FREEZE Soft Serve Model GEN 2080 16 185240 5 Part Names and Functions Shake Figure 5 2...
