ELECTRO FREEZE Soft Serve Model GEN-2080
56
185240
Cover - Must be
in place to operate.
Mix Level
Probe Cord
Mix Pickup Tube
Mix Tank
Mix Level Probe
Cover - Must be
in place to operate.
Mix Level
Probe Cord
Mix Pickup Tube
Mix Tank
Mix Level Probe
14.2 Draining Product
14.1 Night Switch Operation
14 Closing Procedures
1. In areas where state and local
health codes will allow, the soft serve side
of model GEN-2080 may be switched to
standby, which will allow the freezer to
cycle all night and maintain approximately
38°F (3.3°C) or lower product in the
cylinder and cabinet.
2. To switch the freezer to the
standby mode press L2 or R2 (figure 14-1)
3. Remove serrated nozzle and
clean the drip tray assembly and all
soiled surfaces with soap and water. Use
sanitizing solution in a spray bottle and
brush to clean the bottom of the plunger
openings.
6. To start the machine after using
standby mode press 4
(figure 14-
1).
Before replacing sanitized nozzle, use
a small brush and sanitizer to clean the
bottom of the plunger openings.
— continued
Figure 14-1
At the end of each day of operation, the freezer must be rinsed, sanitized, and
disassembled. The parts also must be washed, rinsed, sanitized, and prepared for
reassembly.
To remove frozen product from the
cylinders:
1. Press the L1 & R1 keys to enter
“CLEAN” mode.
2. In “CLEAN” mode press L1 & R1 to
turn the beaters on and let the beaters
run for 5 minutes. This will allow the
product in the cylinders to soften.
3. In the cabinet below (see figure 9-1).
Disconnect the mix probe cords from
the back of the cabinet.
4. Remove each mix tanks while pulling
the stainless steel pickup tube from
the mix tank. Place the pickup tubes
in a clean sanitized container.
5. Mix must be handled according to
local health codes.
6. Place a clean sanitized container
under the dispensing head.
7. Very slowly open the side spigots and
dispense the semi-frozen product until
it quits dispensing. To eliminate waste,
dispense as much as possible for use
in pints, quarts, and/or novelties.
L1
2
3
4
5
6 7 8
9
10
2
4
L2
R1
R2
1
LEFT
RIGHT
OFF
OFF
Figure 14-1
Summary of Contents for Electro-Freeze Genesis Series
Page 2: ......
Page 10: ......
Page 26: ...ELECTRO FREEZE Soft Serve Model GEN 2080 16 185240 5 Part Names and Functions Shake Figure 5 2...