H-Germany HEYNER SafeUp AERO L, Instruction Manual

English

English

 GB

9

10

3. Care Instructions

To wash the seat cover, simply peel it off in an upwards motion. 

The cover can be washed at 85ºF/30ºC.

Attention:

 Please do not spin. Do not dry in a dryer.

4. Important Notices

•   The 

HEYNER® SafeUp AERO L

 child seat is approved in accordance to the European 

    Standard for child restraint systems 

ECE R44/04

. The test symbol as well as the 

  permit number can be found on the orange label at the bottom of the seat.

•   This child seat can only be used in vehicles with three-point seat-belts, 

  that are approved by the ECE regulation No.16 or other comparable standards. 

  It is strictly forbidden to install this seat with the lap belt alone.

•  It is not allowed to do any changes on the seat or the belts.

•  Each change of any part of the seat, which is not done by the manufacturer, 

  will cause the expiration of the ECE- approval and excludes immediately any warranties.

•  Should any doubts or problems occur, contact your supplier, dealer or 

HEYNER MOBIL AUTOMOTIVE GMBH

.

2. Installation in the car

Place the 

HEYNER® SafeUp AERO L

 on the car seat, set your child in and 

secure your child with the lap (

O

) and diagonal belts (

N

) of the three-point-

vehicle-belt. Now fasten the three-point seat-belt with an audible »

click

« 

sound. Make sure that the lap belt runs under the fixation lugs (

C

) on both 

sides and that the diagonal belt leads only under the fixation lugs (

C

) on 

the side of the belt buckle (

Q

).

Finish the fixing of the belts by fixing the belt block anchor (

D

), only if 

delivered with. This piece makes sure the diagonal belt (

N

) lies firmly over 

the child‘s shoulder and optimizes the belt guidance. Thread the belt block 

anchor (

D

), which is fixed on the back side of the seat part, onto the diagonal 

belt (

N

) at the height just behind the child‘s shoulder. The string to fix the 

belt block anchor to the seat must lead behind the back of the child.

Warning:

Do not fasten the belts in any other way than described here, otherwise 

the child will not be held or secured properly. Make sure that the diagonal belt

 is carefully positioned and does not run too close to the child‘s neck. All belts must lie 

firmly against the child‘s body without twisting. 

If necessary, install a height adjuster mechanism into the car to correspond to your child‘s size.

Attention:

This fixing keeps the booster firmly in place in case of the non activated retracting system. 

Always keep it with the seat as it avoids injury in case of accident!

click