6
9. To install the receiver, the cockpit floor has to be removed from the fuselage. The cockpit
floor design is precise and tight fitted. So please remove it carefully to avoid making
dents on the foam. All the servos wires are well labelled. Please connect the servo leads
correspond to the channels on your receiver.
10. Then tuck the receiver into the compartment and install the cockpit floor back into place.
Ensure that the placement of the receiver will not interfere with the servo horns inside.
Note: Make sure that the propeller is not being installed on the motor
shaft at this moment.
You may switch on your R/C system and check if there is any
interference with the setup. You may install the prop later when the RC system has been
completely setup.
Summary of Contents for Cessna Skyline
