3. Installation of spray cup for door/window
As shown in Figure 4 and Figure 5, install the two small hooks of the spray cup for
door/window and then trigger the big hook of the spray cup for door/window, and push the
spray cup for door/window up and clutch it onto the body of the general spray nozzle.
Refill water during operation
1. Unplug the power cord and disconnect the power
supply.
2. Press down the steam button to release the
pressure until no steam is injected out.
3. Slowly unscrew the safety cap but do not remove
it, and residual steam will be discharged slowly until
no steam cornes out. Then place the machine in a
cool place to cool it down for about five minutes.
Finally, completely remove the safety cap.
4. Use the funnel and measuring cup to refill a
suitable quantity of cold or hot water into the tank.
5. Re-install the safety cap onto the machine body
and tighten it in position.