maintenance and safety inspections
file: n:\article\cos14310m5-v1_07hpc-en\20130207_cos14310m5-v1.07hpc-en_h-p-cosmos_treadmill_manual.doc
© 2013 h/p/cosmos sports & medical gmbh author: fh email@h-p-cosmos.com created 07.02.2013 printed 04.03.2013 page: 113 of 197
8.4.1
Devices with UserTerminal and without automatic oil-pump
Devices with a UserTerminal are equipped with an automatic oil indicator in the UserTerminal display. At the
standard setting the word OIL flashes on the display after 1000 km. (Special devices may have different intervals.)
After lubrication, reset the oil message to "OP01". The device has no sensor and the oil message will not
disappear automatically after lubrication! The lubrication of the running belt and running surface is done with the
accessories (bottle of lubricant and 10 ml syringe) in the scope of delivery.
Use only the provided lubricant. Other available oils and lubricants
may damage the running belt and running surface and lead to a
breakdown of the running machine. Lubricant is available on request
at h/p/cosmos. The running belt should be lubricated after 1000 km
at the latest and/or if dry grinding noises are heard during operation.
Special devices may have different lubrication intervals.
Use the oil filling hole [1] at the right hand side in front of the motor
hood [2] between the footboard [3] and the running belt [4] to refill oil.
The lower surface (gliding on the deck surface) of the running belt
has a fabric construction which accumulates and distributes the oil
until the next oiling is due.
Oiling amount
Oil in the amount of 3 syringes each filled with 10 ml of silicone oil. (Special devices may have different oiling
amounts - see delivery papers). In addition, 1 syringe filled with air should be added in order to empty the oil line in
the running machine.
Procedure
N
Start the running machine at a max. speed of 5 km/h.
N
Fill the syringe with 10ml of the lubricant.
N
Insert the syringe into the oil-filling hole and press the content in
slowly.
N
Repeat this procedure two more times.
N
Fill the syringe with air and slowly press the air into the oil-filling
hole. This will empty the small oil-tube of the running machine.
N
Clean the area around the oil-filling hole so that it is free of
spilled oil.
N
Let the running machine operate for a few minutes at the speed of 5 km/h, so that the oil is distributed on the
inside of the running belt. Walk for 2 minutes at very low speed (ca. 2 km/h) while varying your position on the
running belt. This will allow the oil under the belt to distribute evenly.
N
Check the position of the running belt after lubrication. The belt should be in a centre position on the rear roller
(tail shaft). If the belt needs to be adjusted, please follow the separate instructions.
N
After lubrication, the oil message should be reset to "OP01" (see
“Reset of oil-message” in chapter entitled “Optional functions”). The
device has no sensor and the oil message will not switch off
automatically after lubrication.
This oil type must not be used for running decks suited for cycle and
wheelchair applications (e.g. saturn 300/100r); neither should it be used
for oil-tanks with an automatic oil-pump. (See separate chapters.)
Special oil 0.25 l – bottle for sliding plate with manual lubrication [cos000200008001]
Syringe 10 ml for lubrication of sliding plate [cos12181]
