maintenance and safety inspections
file: n:\article\cos14310m5-v1_08hpc-en\20150130_cos14310m5-v1.08hpc-en_instructions_for_use_h-p-cosmos_treadmill.doc
© 2015 h/p/cosmos sports & medical gmbh author: fh email@h-p-cosmos.com created 30.01.2015 printed 30.01.2015 page: 126 of 216
8.4.7
Resetting of oil message
An external UserTerminal or the PC-software h/p/cosmos para control
®
is required for devices without
UserTerminal.
Initiation: running belt is not moving. One of the mode LEDs
is flashing: manual, profile, cardio, test
Step
Activity
Keys
Response/Display
[01]
Select of the mode for "user
options" (OPxx)
a
d
b
press 3 keys
simultaneously for
at least 3 seconds
=
indicates: OP01 flashing (for option no. 01)
!
and
"
indicate: E.rE SEt (for error reset)
[02]
Confirm option no. 1
c
§
indicates “donE" to inform you that the oil
message must be deleted.
[03]
Delete message
c
=
indicates: OP01 flashing (for option no. 01)
!
and
"
indicate: E.rE SEt (for error reset)
[04]
Quit option mode
b
Stand-by mode
manual, profile, cardio or test is flashing
8.5
Control and tightening of the running belt
The belt may loosen after a while or if it has been adjusted wrongly. In this case a backlash occurs between the driving
shaft and the belt, i.e. when weight is applied to the belt by stepping on it, the belt slows down.
The belt tension should be checked as follows:
N
Visually inspect the surface for cracks. In case of a crack replace
running belt immediately.
N
Open the motor hood at the front. Take care that nobody gets his
hands into the motor.
N
Press the "START/Enter" key for manual mode and select a
speed of 1 to 1.5 km/h with the help of the "+"/"-" keys.
N
Stand on the running belt. Hold on to the side handrails with both
hands and try to block the rotation of the running belt by
stemming yourself against the belt with your feet. If necessary, 2
people can do this.
N
Try to block the movement of the running belt for max. 10
seconds. The driving shaft and the motor shaft should not be
turning during that time. Otherwise the running belt has to be
tightened (or the driving belt).
If the running belt is blocked too long, the motor regulation can switch off because of excess
current, which will be indicated by an error display. In this case, switch off the device for 5 minutes
and then switch it on again. The belt tension should not be more than 0.5 %, otherwise it could
damage the belt, the shafts or the bearings!
