maintenance and safety inspections
file: n:\article\cos14310m5-v1_08hpc-en\20150130_cos14310m5-v1.08hpc-en_instructions_for_use_h-p-cosmos_treadmill.doc
© 2015 h/p/cosmos sports & medical gmbh author: fh email@h-p-cosmos.com created 30.01.2015 printed 30.01.2015 page: 128 of 216
N
The adjustment procedure is finished if the running belt stays in the centre of the rear roller (tail shaft) after having
been operated at a speed of 12 km/h for at least 4 min.
N
Uphill run and other running styles may lead to locomotion of the running belt. +/- 2 cm are to be considered as a
tolerance zone. As long as the running belt returns to the centre at a speed of
12 km/h, it must not be readjusted. The running belt will remain in the
adjusted position for a period of months if it has been adjusted correctly.
N
During "reverse belt rotation" (downhill run), a re-adjustment of the belt
position (centring) is required.
N
By evenly turning the left and right trimming screws to the right, the running
belt can be tightened if necessary. See chapter „running belt tension“.
Note: The running belt always has to be positioned within the marking for the correct lateral position.
Note: For running machines with a running surface of 200 x 75 cm and bigger, the trimming screw is located at the front
deviation shaft.
The allen key must be pulled out of the screw immediately after use due to risk of injury!
The oversize machine h/p/cosmos saturn 450/300rs has an automatic belt centring system with motors and sensors and
does not need to be centred manually; however, the user should observe the central belt position.
