|
17
Automatic Charger AL800
– Do not expose the device to rain or moisture to avoid a fire hazard and the
danger of an electric shock.
– Do not allow liquids of any kind to penetrate into the device.
– Never cover the ventilation slots or housing.
– Do not place the device near hot air sources such as radiators or similar.
– Never charge batteries in a boat or watercraft. Take the battery out of the
boat or watercraft before charging.
– In case of misuse (e.g. incorrect battery type or too long polarity reversal.) the
battery can be overcharged or damaged. In the worst case, the battery can
explode and can cause considerable damage.
– Keep the transmitters (mobile phones, transmitters for modelling etc.) away
from the charger since the incoming sender radiation can result in the failure of
the charging device or destruction of the charger and therefore the batteries.
– Handle the product carefully, thrusts, blows and dropping from even little
height will cause damage. A faulty device must no longer be used and must
therefore be disposed of.
– Do not expose the device to sunlight, strong dust formation, mechanic
vibrations or thrusts.
– Never put or lead the charging cable near to inflammable materials. The
charging cable may neither be kinked nor be led over sharp-edged parts.
– Ensure that no inflammable objects (wood, cloths, cleaning rags or similar) are
placed near the device. The mains or charger leads must not be modified,
extended or shortened. In addition, the leads must neither be bent, squashed
nor be guided through square-edged parts.
– Live cables or lines, which are connected to the device, must always be tested
before and after use for insulation faults or breakages.
– Immediately discontinue using the device, if an error is determined in the
supply cable.
– If necessary, use an appropriate non-inflammable basis (e.g. a big, thick wall
tile or flagstone).
– Only use the device outside of the vehicle.
– Only start using the device outside of the vehicle. Ensure that a secure and
stable connection is established when connecting the battery charging
clamps.
– Never use in the case of adverse ambient conditions. Adverse ambient
conditions are: Ambient temperatures below –25 °C or above +50 °C,
Summary of Contents for 2420.0004
