18
Leipzig
H.
WINTER HP-11 PB DELUXE
For more informa on visit h p://www.winter-holztechnik.de
SECTION 8 : ADJUSTMENT INSTRUCTION
-------------------------------------------------------------------------------------
Adjust saw blade height
To adjust the saw blade head left to right:
1.
Disconnect the resaw from the power
source!
2.
Use your test board to determine which
direction the conveyor table needs to be
moved. For example,
if the right side of the
board was thicker than the left side
—you
will need to move either the right side of the
saw blade head
or move the left side of the
saw
blade head
down.
3.
Loosen the cap screw shown below.
4.
The adjusting nut shown in raises,
or lowers, the non-drive side of the bandsaw
blade (the side
opposite the motor). Insert the
pry tool into the adjusting nut.
—Rotate the adjusting nut to the right to raise
the bandsaw blade.
—Rotate the adjusting nut to the left to lower
the bandsaw blade.
5.
Retighten the cap screws, connect the resaw
to the power, and repeat steps 1 and 2.
—If the measurements are close to correct,
but need fine tuning, continue to step 6.
—If large adjustments are necessary, repeat
steps 3 and 4.
