19
Leipzig
H.
WINTER HP-11 PB DELUXE
For more informa on visit h p://www.winter-holztechnik.de
Adjust in-feed pressure roller
in right /left direction
The in-feed roller is pressed by air unit. Adjust the pressure when pressing the wood piece over or less.
Make sure to lift up the
front
roller and fix on top when saw blade
is
higher than 60mm, nor
the roller will be cut by blade!
Adjust conveyor belt
1.
Lossen the two roller bracket cap screws on the both side of the conveyor about 3/4 of a turn.
2.
Loosen the rear adjustment nuts on both side of the conveyor.
3.
Start conveyor belt.
4.
Adjust the roller bracket that the belt is hitting by turning the
front adjustment nut counter-clock wide
half of a turn, and watch the belt tracking. Note
—
The effect of the adjustment
can sometimes take two minutes before the
results are fully apparent.
—
If the tracking was not corrected by this
adjustment, proceed to step 5. If the
tracking was
corrected, skip to step 6.
Winter Machinery
recommends using 40 psi.