20
Leipzig
H.
WINTER HP-11 PB DELUXE
For more informa on visit h p://www.winter-holztechnik.de
5.
On the side that the belt tracks away from,
turn the front adjustment nut clockwise half
of a turn, and
watch the belt tracking.
—
If the tracking was not corrected by this
adjustment, repeat step 4.
6.
When the conveyor belt is tracking in the
center of the roller brackets, run the conveyor
for at least
two
minutes to ensure that
it will remain tracking correctly.
—If the tracking was not corrected by this
adjustment, repeat step 4.
—If the belt is tracking in the center of the
in-feed roller, but not centered on the
out-feed roller, go to
step 7.
—If the belt is tracking in the center of both
rollers, go to step 9.
7.
Adjust the out-feed
end of the conveyor by
loosening the bolts on the out-feed bearing
housing
(similar to the bearing housing)
and sliding it forward or
backwards.
8.
Retighten the bearing housing bolts and run
the conveyor to check the tracking.
—If the tracking was not corrected by this
adjustment, repeat
step 7.
9.
Tighten the rear adjustment nuts against the
bracket plates, and then
tighten the front adjustment
nuts
against the bracket plates to make
sure that the tracking adjustment will not
slowly change during
normal operation.
< Conveyor Pressure Gauge:
50
NOTICE
：
These instructions
are for rough tensioning only. The only way to accurately tension the
blade is with a blade tension. Premature blade breakage is often caused by improper
blade
tensioning.
Replacing conveyor
To replace the conveyor belts
：
1. Start the
conveyor belt and stop it when the conveyor belt seam is accessible.
