15
Belt Tension & Replacement
1.
Note Belts should be replaced as a matched set
of four
2.
Pull out on the lever at the fore side of the
machine, and raise the hood
3.
Loosen the three bolts (, Figure 8) which hold the
motor support bracket to the frame.
4.
Turn the hex nuts on the tension rod as needed.
5.
When finished, tighten the three bolts closed the
hood and turn off the brake release button
Figure 8
Drive Chain Replacement
The drive chains do not require tension adjustment,
since tension is always assured by an idle chain
tension.
To replace the main drive chain, pull the tensioner
backward and remove the chain from around the
sprockets. When the new chain has been mounted,
always make sure the tensioner is well placed on the
chain
To replace the chain for the table raising mechanism,
pull the lever to the back and remove the chain.
When the new chain has been mounted, push the
lever ) back into position.
Do not turn the sprockets on the
table raising screws with the chain
removed. Doing so will misalign the
table
Feed Rollers
The infeed and outfeed rollers and chipbreaker have
been factory set. However, if spring tension
adjustment should ever be necessary, use the
appropriate adjustment assembly located beneath
the lip of the frame – one is shown if figure 9.
1.
Loosen the nut and turn the screw in or out
2.
When finished, tighten nut.
3.
Perform the same adjustment at the opposite
end of the roller.
Figure 9
