WINTER TIMBERMAX 4 – 23 ECO
6
3.
Operational requirements of machine tool.
3.1
Environment required for machine tool
①
Ambient temperature:5~40
℃
②
Relative humidity: 30~95%
③
Height above sea level of machine use: max. 1000m.
④
Transportation and storage temperature: –25~55
℃
, 70
℃
acceptable within 24 hours.
⑤
Do not use the machine in explosive environment.
3.2
Power supply, Pneumatic power, Dust collecting and Lubrication
①
Power supply:
Three-phase alternating current, Frequency 50±1%Hz, Voltage 380±10%V and Motor
power (please see the parameter table).
②
Pneumatic power
Dry, filtered and lubricated compressed air. Pressure used should be 0.5~0.8Mpa and the
connector should be plastic hose of OD(Outter Diameter) 8mm.
③
Dust collecting:
Wind speed must be 30 – 34 m/s, dust-intakes of ID (Inner Diameter)120mm, wind cost
(m³/h) please see the table below.
TABLE
2
4 spindle machine
5 spindle machine
Wind
Min.
4900
6110
Max.
5540
6930
④
Lubrication
Using all of high temperature lubrication above 120ºC, Ca-based Grease ZG-3 ,ZG-0, engine oil
N46.
4
.
Main purpose of machine tool
Mainly used for synchronized working on four sides of wood block, wood bar, floor batten,
window and door frame, furniture component, etc. It can also be used for shape planing when
fixing special-purposed cutters, such as armrest of stairs and so on.
5.
Brief introduction of machine tool and main technical parameters
5.1
Brief introduction of machine tool
The machine tool is built-up by operation device, guiding of workpieces, spindles, safety
device, elevation device and so on.
Take RMM523UE for example, its configuration please see.