WINTER TIMBERMAX 4 – 23 ECO
18
8.2
Cutter block installation
Cutter block installation: Please see
(
Figure9
)
①
Loosen and remove the locknut 5 by wrench 7, then take out the locking washer 3 and
pressure cap 4.
②
Clean and grease the OD of spindle 1, inner of cutter 2, then install cutter 2 and cutter ring 3
onto the spindle.
③
Install spindle pressure cap 4 and locknut 5, use the wrench 7 to lock the locknut 5 on the
spindle.
Attention
:
a. The blades should be in a same cutting circle while installing the blades.
Especially ensure
that the nips of blades must be firmly installed and check each locknut carefully. Or
else it would be very dangerous if the blades fly out.
b. Do not beat to lock or Loosen the locknut 5 while installing cutter blocks, for fear that
damage of spindle and locknut would occur.
The usage of wrench for spindle nut
:
Lock the spindle by small wrench 6 then rotate big wrench 7 to lock or loosen locknut 5.
Please see
(
Figure9
)
(
Figure9
)