WINTER TIMBERMAX 4 – 23 ECO
30
8.11
Adjustment of insert and fence
When left and right spindles are using cutters of small diameters, insert 1 is needed. With
cutters of big diameters, the insert 1 should be removed. While using cutters of small diameters,
the position of board 2 can be adjusted according to the rotate OD of cutters. Loosen locknut 3
and adjust, please see
（
Figure24
）
（
Figure24
）
8.12
Side pressure board of left spindle adjustment
①
Install one cutter with measured dimention (e.g. cutter with radius R=60), press cutter
adjusting ruler firmly onto the rear pressure board 1, loosen bolt 3, adjusting screw 4 to
make tangency of cutter’s cutting blade and cutter adjusting ruler. Set the value of readout 5
into 60. Lock bolt 3.
（
Figure25
）
②
Press cutter adjusting ruler firmly onto the side pressure board 12, adjusting bart 7 and 8,
Keep side pressure wheel 9 and 10 together with side pressure board 12 a beeline and
parallels the guiding board.
③
While using different cutters, loosen bolt 2 and 11 then adjust the left and right position of
rear pressure board 1 and side pressure board 12 separately. Adjust screw 4 to ensure
3~5mm compressed quantity side pressure board and cutter (namely adjust compaction).
④
Rotate bar 6, 7 and 8. to adjust impaction of side pressure board 12, adjusting wheel 9 and
10 separately.
（
Figure25
）
