WINTER TIMBERMAX 4 – 23 ECO
31
8.13
Adjustment of front and rear pressure device of top spindle
The adjustment of front and rear pressure device of top spindle is according to the dia. of
cutter used. Keep the rear pressure part 2 0.5~1mm (compressed quantity) lower than cutter
edge 3. Chip-breaker 4 is of 3~5mm compressed quantity. The pressure shoe must be adjusted
to the center of the width of workpiece.
Looson bolt 1 to adjust the up/down position of rear pressure part 2. Loosen bolt 5 to
adjust the up/down position of front chip breaker 4. See
(
Figure26
)
. Rotate bar 6 to adjust the
pressure of front chip breaker.
(
Figure26
)