WINTER TIMBERMAX 4 – 23 ECO
35
8.16
Pressure adjustment
The pressure of feeding wheels can be adjusted separately. While adjusting pressure, pull
out the pressure adjustment knob and rotate left or right until the finger points to the value in
need. Then press the knob back to primary position. Please see
(
Figure30
)
1st section of feeding steel wheel
①
pressure setting: 0.1
~
0.2MPa
2nd section of feeding steel wheel
②
pressure setting: 0.2
~
0.3Mpa
3rd section of feeding rubber wheel
③
pressure setting: 0.3
~
0.4Mpa
3
2
1
pressure indicator
pressure adjusting knob
(
Figure30
)
8.17
Loose and tight of spindle belt
①
Loose and tight of horizontal spindle belt
The loose and tight of horizontal spindle belt please see
(
Figure31
)
: Mainly depend on the
motor weight to adjust the loose and tight of belt, adjust nut 1 and 3 at one time, by dint of
tension of spring 2 to increase the loose or tight of the belt.
。
(
Figure31
)