WINTER TIMBERMAX 4 – 23 ECO
36
②
Loose and tight of vertical spindle belt
The loose and tight of vertical spindle belt please see
(
Figure32
)
: Loosen lockbolt 1 and
bolt 2 of motor, adjust bolt 3 to adjust the loose or tight of spindle belt, screw nut 1 and bolt 2
after finished.
(
Figure32
)
9.
Test run of machine tool
9.1
Electric test run of machine tool
①
Check the insulated resistance of electric equipment before the first electrify. This can only
be done by qualified electrician.
②
According to the power on the brand and the attached technical requirement of electric
principle, select correspond cross-sectional area of three-phase four-conductor cable.
③
Power supply cable goes throught from Pg29 of the bottom of electric box. Let cables L1,
L2, L3 meet the homonymous terminals on the left in the electric box. Protected earthing
will meet the bottom-left terminals of the electric box. Please see
(
Figure33
)
(
Figure33
)