WINTER TIMBERMAX 4 – 23 ECO
39
11
.
General troubles and trouble-shooting methods
11.1
Troubles and trouble-shooting methods of workpiece
TABLE 9
No.
Troubles
Possible causes
Trouble-shooting method
1
Nibbles appear on the
workpiece
The blades are not level with the
guiding fence or the table
Re-adjust
2
The workpiece bows while
planing
Cutter of planing does not adjusted
precise enough relative to the table
or cutter blunt.
Re-adjust the working table
relative to the table.
3
The workpiece twists
①
The feeding pressure wheel deviates
②
One side of the level-planing cutter
wears out seriously because of
processing the raw wood block with
same width frequently
①
Re-adjust the pressure wheel
to the center of workpiece
②
Re-sharpen the planing cutter
4
The
workpieces
are
unparalleled to each other
in width direction
①
The cutter edge is unparalleled
to the machine table.
②
One side of the blade wears out
①
Re-adjust the cutter.
②
Re-sharpen the cutter
5
The workpieces are unparalleled to
each other in length direction
The pressure of front and rear
pressure shoe of top spindle is
not enough.
Re-adjust the pressure of
front and rear pressure shoe
of top spindle
6
The
workpieces
are
unparalleled to each other in
length direction of both ends
The fence of right spindle
unparalleled which is caused
by
the
lossed
while
processing.
拧紧小靠尺，重新调整前后
靠尺，使其相互平行。
