WINTER TIMBERMAX 4 – 23 ECO
5
No.
Symbols
Instruction of Symbols
9
PE
Earthing
10
Pneumatic power entrance.
（
0.5~0.8MPa
）
（
CE machine
）
11
TH E O U TER CO VER CAN O N LY BE O PEN ED
AFTER TH E SAFETY IN D ICATO R TU R N S O N
ATTEN TION !
The outer cover can only be opened
after the safety indicator turns on.
（
CE machine
）
12
ATTEN TIO N !
＂ ＂
PN EU M ATIC AIR SOU RCE H AS N O T BEEN TUR NED OFF
AFTER M AIN SW ITCH IS DISCON NECTED .
OPEN SWITCHBOARD ONLY WHEN THE MAIN
SWITCH IS IN THE“0“POSITION
Open switchboard only when the
main switch is in the “0” position.
Pneumatic air source has not been
turned off after main switch is
disconnected.
（
CE machine
）
2.3
Correct use of machine tool
①
The processing range of workpieces only limit to the data of technical parameters. Do not use
if the data overruns.
②
Do not process the timber with nail or concrete.
③
The cutter tools must be made in accordance with
EN847-1
manufactured saw blade and
milling cutter
④
Check the locking state of cutter blocks before operating the machine. Let the machine run
with nothing for at least 5 minutes to inspect running state, to get rid of obstructions in time.
⑤
Lay the timber onto the infeed table and push hardly to the guiding fence one by one.
⑥
To avoid spring of workpieces, adjust the height of infeed wheels matching the height of
workpieces, and ensure enough feeding power.
⑦
Do not change speed when the machine is stopped, in case of causing damage to the machine.
⑧
Press emergency stop to examine and repair when trouble comes out.
⑨
Let the machine run with nothing to clean up the chips after processing.
