27
DO NOT DIVE.
101
DO NOT DIVE.
REGULAR MAINTENANCE PROCEDURES
NOTE: These maintenance procedures are the responsibility of the swim spa owner to perform.
These procedures are not covered by the swim spa warranty.
CARE OF LAMINAR FLOW JETS:
In order to keep your Laminar Flow Jets operating properly, follow these instructions in sequence:
- Turn off Laminar Flow Jets
- Remove outer ring by turning face counter clockwise
- Remove internal Jet insert with a pair of needle nose pliers
- Clean plastic filter at the back of the Jet insert so all holes are free of debris
- Reinstall Jet insert and outer ring
NOTE:
To prevent premature failure of your swim spa cover and the possibility of water running out
of the swim spa off the bottom of the cover, always turn Laminar Flow Jets down so that they do
not hit the cover when the cover is closed. You do not want to completely turn jets off. Doing so
may cause a build up of stagnant water in the water line if not used often.
CARE OF YOUR OZONE SYSTEM:
The ozone hose and check valve connecting between the ozone generator and ozone injector
should be inspected and/or replaced, if necessary, every 12 months. Depending on conditions of
the air which is being brought in to the ozone generator, the ozone hose and check valve can
wear more rapidly. This regular maintenance is not covered under the swim spa warranty. We
recommend that your Master Spas Dealer or Service Center be contacted to perform this type of
maintenance.
