Installation Manual
H3C SecPath F100-A Firewall
Chapter 3 Firewall Installation
3-6
III. Connecting the Ethernet cable
Take the LAN0 interface on the front panel of the H3C SecPath F100-A firewall for
example. Follow these steps to connect its Ethernet cable:
Caution:
Read the symbol above the interface carefully to avoid misconnection.
Step 1: Connect one end of the Ethernet cable to the firewall and the other end to the
peer device.
Step 2: Check that the LINK/ACT LED corresponding to LAN0 is on. ON means a link is
present on the interface. OFF means no link is present on the interface and you should
check the connection.
3.6 Connecting the Power Cord
The H3C SecPath F100-A firewall has AC-powered model.
I. AC power supply
AC input: 100 VAC to 240 VAC, 50 Hz or 60 Hz
Figure 1-2 shows the power socket on an AC-powered model.
II. Recommended AC power socket
You are recommended to use a single-phase three-terminal socket with an earth
contact, which must be properly grounded. The building ground system is often buried
during the wiring engineering. Make sure that the building ground system is normal
before connecting the AC power cord.
III. Connecting the AC power cord
Step 1: Make sure that the grounding screw on the chassis is securely connected to the
earth ground.
Step 2: Make sure that the power switch is in the OFF position. Connect one end of the
AC power cord to the AC-input socket (100 VAC to 240 VAC) on the left end of the rear
panel and the other end to the AC site power.
Step 3: Push the site power to ON position.
Step 4: Push the power switch of the firewall to ON position.
Step 5: Check that the PWR LED on the front panel is on. ON means the power
connection is correct.
