9-1
9
Installing fabric modules
CAUTION:
•
If you are not to install a fabric module in a fabric module slot, keep the filler panel in the slot.
•
The router does not allow a mixture of different models of fabric modules.
•
When you install a fabric module, avoid touching the connectors on it.
Installing a fabric module
The router provides six vertical fabric module slots at the rear and comes with all the fabric module
slots empty.
The router supports N+1 fabric module redundancy. You can install two to six fabric modules for the
router.
To install a fabric module:
1.
Place the fabric module on a workbench and remove the protection box from the connector
side of the fabric module.
Figure 9-1 Removing the protection box
2.
Press the spring clip for each ejector lever of the fabric module to release the ejector levers.
3.
Orient the fabric module with the "Up" sign facing up. Align the fabric module with the target
slot and then insert it into the slot along the guide rails.
4.
Continue to push the fabric module until the brakes on its ejector levers touch the slot edges
tightly. Simultaneously close the two ejector levers until the spring clips lock the ejector levers
in place.
Summary of Contents for CR19000-16
Page 16: ...4 3 Figure 4 3 Mounting the router in a rack...
Page 25: ...6 8 Figure 6 6 Connecting an AC power cord using a releasable cable tie...
Page 36: ...9 3 Figure 9 3 Installing a filler panel in a fabric module slot...
Page 38: ...10 2 Figure 10 1 Installing a fan tray...
