3-5
Figure 3-7
Attach the 1U mounting bracket for center mounting
Figure 3-8
Attach the 1U mounting bracket for rear mounting
Note that each of the above figures shows only how to install one 1U bracket, because the installation
procedures of the two brackets are the same.
Figure 3-9
Attach the 2U cable management bracket and mounting bracket kits
Note that if the 2U mounting bracket is used for a center mounting of the S5800-60C-PWR, you need to
separate the mounting bracket and cable management bracket (they are fixed by default; to separate
them, use a screwdriver to loosen the three captive screws, as shown in
Figure 3-10
). Then follow the
steps above to attach the mounting brackets to the switch.
