Command Manual – RRPP
H3C S7500E Series Ethernet Switches
Chapter 1 RRPP Configuration Commands
1-12
<Sysname> system-view
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] ring 20 node-mode edge common-port gigabitethernet
3/0/1 edge-port gigabitethernet 3/0/2
# Specify the device as the assistant edge node of primary ring 20 in RRPP domain 1,
GigabitEthernet 3/0/1 as the common port and GigabitEthernet 3/0/2 as the edge port.
<Sysname> system-view
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] ring 20 node-mode assistant-edge common-port
gigabitethernet 3/0/1 edge-port gigabitethernet 3/0/2
1.1.7 ring enable
Syntax
ring ring-id enable
undo ring ring-id enable
View
RRPP domain view
Parameters
ring-id
: RRPP ring ID, in the range 1 to 64.
Description
Use the
ring enable
command to enable the RRPP ring.
Use the
undo ring enable
command to disable the RRPP ring.
By default, the RRPP ring is disabled.
Note that:
z
To enable subrings, you must first enable the primary ring before enabling
subrings.
z
You must first disable all the subrings in the RRPP domain and then disable the
primary ring.
z
To activate the RRPP domain, RRPP protocol and the RRPP ring must be
enabled simultaneously.
Related commands:
rrpp enable
.
Examples
# Enable RRPP ring 10 in RRPP domain 1.
<Sysname> system-view
[Sysname] rrpp domain 1
