Command Manual – Login
H3C S7500E Series Ethernet Switches
Chapter 1 Commands for Logging into an
Ethernet Switch
1-30
Use the
undo user privilege level
command to revert to the default command level.
By default, the commands of level 3 are available to the users logging into the AUX user
interface. The commands of level 0 are available to the users logging into VTY user
interfaces.
Examples
# Configure that commands of level 0 are available to the users logging into VTY 0.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface vty 0
[Sysname-ui-vty0] user privilege level 0
# You can verify the above configuration by Telnetting to VTY 0 and displaying the
available commands, as listed in the following.
<Sysname> ?
User view commands:
cluster Run cluster command
language-mode Specify the language environment
ping Ping function
quit Exit from current command view
super Set the current user priority level
telnet Establish one TELNET connection
tracert Trace route function
undo Undo a command or set to its default status
