Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Chapter 5 IPv6 BGP Configuration Commands
5-53
Parameters
ipv6-address
: Clears the flap statistics for the specified IPv6 address.
prefix-length
: Prefix length of the address, in the range 1 to 128.
as-path-regexp
: Clears the flap statistics for routes matching the AS path regular
expression.
as-path-acl-number
: Clears the flap statistics for routes matching the AS path ACL. The
number is in the range 1 to 256.
Description
Use the
reset bgp ipv6 flap-info
command to clear IPv6 routing flap statistics.
If no parameters are specified, the flap statistics of all the routes will be cleared
Examples
# Clear the flap statistics of the routes matching AS path ACL 10.
<Sysname> system-view
[Sysname] ip as-path 10 permit ^100.*200$
[Sysname] quit
<Sysname> reset bgp ipv6 flap-info as-path-acl 10
5.1.64 router-id
Syntax
router-id
router-id
undo router-id
View
BGP view
Parameters
router-id
: Router ID in IP address format.
Description
Use the
router-id
command to specify a router ID for the router.
Use the
undo router-id
command to remove a router ID.
To run IPv6 BGP protocol, a router must have a router ID, an unsigned 32-bit integer
and the unique ID of the router in the AS.
A router ID can be configured manually. If not, the system will select a router ID
automatically from the current interfaces’ IPv4 addresses. The selection sequence is
